29
1. Move fence adjacent to right miter gauge and
secure to the guide tube by lowering the fence
clamping lever.
2. If the fence face (A) figure 36, is not parallel to the
miter slot (B), raise the clamping lever and lift the
fence and place it on the saw table.
3. Adjust the one or both of the set screws (C) 1/4
turn or less.
4. Replace fence on guide tube and repeat steps 1
through 3. If fence is closer to parallel, turn the set
screw in the same direction but a little less. If the
fence is further out of parallel, turn the set screw in
the opposite direction.
5. Repeat steps 1 through 3.
1. Move fence over the cast iron table and secure
to the guide tube by lowering the fence clamping
lever.
2. Use a square to check that the fence face is
perpendicular to the table.
3. If the fence face is not perpendicular to the table,
release the clamping lever and slightly adjust one
of the slotted set screws (A) figure 37 until the
fence face is perpendicular to the table.
4. Secure the fence to the guide tube to insure the
fence remains perpendicular. If not, repeat steps 1
through 4.
A
B
C
A
To Next Page
Loading...
Need help?
General
