31
A complete line of accessories is available from your DELTA
®
Supplier, DELTA
®
Factory Service Centers,
and DELTA
®
Factory Service Centers, and DELTA
®
Authorized Service Centers. Please visit our Web Site
for an online catalog or for the name or your nearest supplier.
For assistance with your machine, visit our website at for a list of service centers
or call DELTA® Power Equipment Customer Care at 1-800-223-7278.
If your machine fails to start, check to make sure the prongs on the cord plug are making good contact in the
receptacle, and check reset button on power switch housing. Also, check for blown fuses or open circuit breakers in
your power line.
Wear certified safety equipment for eye, hearing and
respiratory protection while using compressed air.
: Keep this area free of
dust and debris buildup. Blow out area regularly with
compressed air.
Keep the worm gears free of dust
and debris buildup. Blow out area regularly with
compressed air. Use a lithium-based multipurpose
grease as needed on these gears.
NOTE: Debris can also be removed
from the saw from below the throat plate, inside the
dust port.
To reduce the risk of injury, turn unit off and disconnect it from power source before cleaning or servicing, before
installing and removing accessories, before adjusting and when making repairs. An accidental start-up can cause
injury.
Periodically blow out all air passages with dry
compressed air. All plastic parts should be cleaned
with a soft damp cloth. NEVER use solvents to clean
plastic parts. They could possibly dissolve or otherwise
damage the material.
Wear certified safety equipment for eye, hearing and
respiratory protection while using compressed air.
Apply hardwood flooring paste wax to the machine
table occasionally or use a commercially available
protective product designed for this purpose. Follow
the manufacturer’s instructions for use and safety.
To clean cast iron tables of rust, you will need the
following materials: a medium sized scouring pad, a
can of spray lubricant and a can of degreaser. Apply
the spray lubricant and polish the table surface with
the scouring pad. Degrease the table, then apply the
protective product as described above.
To Next Page
Loading...
Need help?
General
