15
Fig. 36
Fig. 35
Fig. 34
Fig. 33
CORD STORAGE
A cord storage bracket (A) Fig. 36, is provided on jointer
base for storage of the cord when machine is not in use.
CHIP AND DUST CHUTE
A chip and dust chute (A) Fig. 35, is provided on the
outfeed end of the jointer base for efficient chip removal.
CAUTION: KEEP HANDS OUT OF CHIP AND DUST
CHUTE AT ALL TIMES.
9. As a final check, run a piece of work slowly over the
knives for 6 to 8 inches. The wood should rest firmly on
both tables as shown in Fig. 34, with no open spaces
under the finished cut.
8. If the knives are set too high, the work will be gouged
at the end of the cut, as shown in Fig. 33.
KNIVES
SET TOO HIGH
IN-FEED TABLE
OUT-FEED
TABLE
CUTTER
IN-FEED TABLE
CUTTER
OUT-FEED
TABLE
KNIVES AT
CORRECT HEIGHT
A
A
GOUGE
MATERIAL
MATERIAL
To Next Page
Loading...
Need help?
General
