Delta DJ-15 User Manual

ADJUSTING FENCE POSITIVE STOPS
I he fence on the jointer is equipped with positive stops at
90 degrees and 45 degrees right and left.
Fig. 19
90 DEGREE POSITIVE STOP
To check the accuracy of the positive stops, position the
lencc at 90 degrees to the table by making certain the end
of plunger (A) Fig. 19. is engaged in notch in the index collar
(B) as shown, and tighten lockhandle (C). Place a square
(D) Fig 20. on the jointer table and against the fence (E).
Fig. 20
If an adjustment is necessary, proceed as follows:
t. Loosen set screw (F) Fig. 21. in the index collar and
loosen the fence locking handle (C).
2. Tilt the fence (C) Fig. 21, until you are certain the fence
is 90 degrees fo the table surface; tighten lockhandle (C)
and set screw (F)
bet the angle ot tilt scale (G) Fig. 21. to the proper
degree mark by loosening screw (Ft) and adjusting the
pointer.
P
Fig. 21
11

Delta DJ-15 Specifications

General

Brand	Delta
Model	DJ-15
Category	Power Tool
Language	English