Denon AVR-1804 Operating Instructions

30
15
LISTENING TO THE RADIO
Auto preset memory
1
1
1
When the main unit’s power operation switch
turn on while pressing the set’s PRESET
DD
button the unit automatically begins searching
for FM broadcast stations.
2
When the first FM broadcast station is found,
that station is stored in the preset memory at
channel A1. Subsequent stations are
automatically stored in order at preset channels
A2 to A8, B1 to B8, C1 to C8, D1 to D8 and E1
to E8, for a maximum of 40 stations.
3
Channel A1 is tuned in after the auto preset
memory operation is completed.
This unit is equipped with a function for automatically searching for FM broadcast stations and storing them in
the preset memory.
The “Auto tuner preset” operation can also be performed at “System setup”. (See page 16.)
NOTES:
• If an FM station cannot be preset automatically due
to poor reception, use the “Manual tuning”
operation to tune in the station, then preset it using
the manual “Preset memory” operation.
• To interrupt this function, press the power operation
switch.
2 DEFAULT VALUE
AUTO TUNER PRESETS
A1 ~ A8 87.5/89.1/98.1/108/90.1/90.1/90.1/90.1 MHz
B1 ~ B8 522/603/999/1404/1611 kHz/90.1/90.1/90.1 MHz
C1 ~ C8 90.1 MHz
D1 ~ D8 90.1 MHz
E1 ~ E8 90.1 MHz
Auto tuning
2 41
3
Press the MODE button to set the auto tuning
mode.
4
Press the TUNING D (+) or H (–) button.
• Automatic searching begins, then stops
when a station is tuned in.
3
1
4
2
Lit
NOTE:
• When in the auto tuning mode on the FM band, the
“STEREO” indicator lights on the display when a
stereo broadcast is tuned in. At open frequencies,
the noise is muted and the “TUNED” and
“STEREO” indicators turn off.
Manual tuning
1
Set the input function to “TUNER”.
3
Press the MODE button to set the manual
tuning mode.
Check that the display’s “AUTO” indicator
turns off.
4
Press the TUNING D or H button to tune in the
desired station.
The frequency changes continuously when the
button is held in.
2
Watching the display, press the BAND button
to select the desired band (AM or FM).
NOTE:
• When the manual tuning mode is set, FM stereo broadcasts are received in monaural and the “STEREO”
indicator turns off.
(Main unit)
1
Set the input source to “TUNER”.
2
Watching the display, press the BAND button
to select the desired band (AM or FM).
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
(Remote control unit)
(Main unit) (Remote control unit)
ENGLISH

Denon AVR-1804 Specifications

General

Brand	Denon
Model	AVR-1804
Category	Receiver
Language	English