4
ENGliSh DEutSch FrANçAiS itAliANo ESpAñol NEDErlANDS SVENSKA
When preparations are complete, start the Setup Wizard.
Use the Setup Wizard to perform connections and settings as shown in the following steps. Perform the operations as described in the
instructions on the screen. You can skip or cancel at each section if necessary.
SETUP WIZARD
This completes the Setup Wizard.
Network Setup
NETWORK SETUP
Please connect LAN cable to
ETHERNET port on rear panel
of receiver, and other side of
cable to network router.
When connection is complete,
press “Next” to continue.
Next
RETURN
Back to TOP
Enter
Configure to playback audio files saved
onto a computer or Internet radio.
These settings can be changed in the following menu even after setting the Setup Wizard
(vm page 110 “Network Setup”).
6
Remote Setup
CABLE
Blu-ray
PVR
CABLE/PVR SAT
CD SAT/PVR
CD Recorder TV
DVD TV/DVD
DVD Recorder TV/VCR
HD DVD VCR
REMOTE SETUP
IPTV STB
Please select the device you want to control.
Enter
RETURN
ReturnSelect
Configure the settings so that devices
connected to this unit can be operated
using the provided remote control.
These settings can be changed in the following menu even after setting the Setup Wizard
(vm page 116 “Remote Setup Guide”).
5
Source Setup
SOURCE SETUP
Please select device.
Source BD
Device Blu-ray Disc player
Player
Video
RETURN
Back to TOP
Enter
Select
Set the connecting terminals for each
device to be set, and connect to the
terminals.
These settings can be changed in the following menu even after setting the Setup Wizard
(vm page 90 “Input Assign”).
4
Speaker Calibration
SPEAKER CALIBRATION
For preparation, the setup
microphone which included
in the box is required.
Please connect the
microphone connector to
the SETUP MIC jack on
front panel.
RETURN
Back to TOP
1 2 3 4
Configure the settings for your speakers,
and for the optimum surround sound for
your room.
These settings can be changed in the following menu even after setting the Setup Wizard
(vm page 21 “Set up speakers (Audyssey
®
Auto Setup)”).
3
Speaker Connection
SPEAKER CONNECTION
Please select the speaker
configuration to be used.
7.1ch adds 2 more speakers
to 5.1ch, for enhanced
surround.
7.1ch
Others
5.1ch
RETURN
Back to TOP
Enter
Select
Connect the speakers for surround sound.
NOTE
Connections for speakers other than 7.1 channel or 5.1
channel speakers cannot be set using the Setup Wizard.
Select “Others”, and then select “Skip” in “2. Speaker Connection” to proceed to “3. Speaker
Calibration”. (For details on the setting method, see m page 59 “Speaker installation/connection
(Advanced connection)”.)
2
Language Select
LANGUAGE SELECT
Please select the language for the on screen menu.
Deutsch
Français
English
RETURN
Back to TOP
Enter
Select
Set the language for the instructions on
the television screen.
These settings can be changed in the following menu
even after setting the Setup Wizard (vm page 118
“Language”).
1
To Next Page
Loading...
Need help?
General
Weight and Dimensions
