Denon AVR-3312 Getting Started

7
ENGliShDEutSchFrANçAiSitAliANoESpAñolNEDErlANDSSVENSKA
Preparation PlaybackSetup Wizard
7
ENGliShDEutSchFrANçAiSitAliANoESpAñolNEDErlANDSSVENSKA
Playback (Basic operation)
Here, we explain how to perform simple operations.
For details, see the included CD-ROM (Owner’s manual).
Important information
Before starting playback, make the connections between the different
devices and the settings on the unit.
NOTE
Also refer to the operating instructions of the connected devices
when playing them.
Selecting the input source
Press the input source select button
(BD, SAT/CBL, TV, NET/USB, DVD,
V.AUX, DOCK, TUNER, GAME1,
GAME2, DVR, CD or PHONO) to be
played back.
The desired input source can be selected
directly.
You can also use the following operation to select an input
source.
nUsing the knob on the main unit
Turn SOURCE SELECT.
•Turning SOURCE SELECT switches the input source, as shown
below.
BD DVD TV SAT/CBL
GAME1GAME2 DVRV.AUX
CDPHONOTUNER
NET/USB DOCK
•When iPod 1 on the main unit is pressed, the input source
of this unit is switched to “DOCK” or “NET/USB” and the
connected iPod is automatically played (vm page 34 “iPod
play function”).
nUsing the “SOURCE SELECT” menu
Switch the remote control unit to the J (MAIN ZONE) mode
when performing this operation (vm page 120 “Operating AV
device”).
If the remote control unit is in K (ZONE2) or L (ZONE3) mode,
the “SOURCE SELECT” menu will not be displayed when SOURCE
SELECT
is pressed.
BD
Recent
Player
Video
Network
Tuner
SOURCE SELECT
Source
The currently selected input
source is highlighted.
q
w
e
q Input Source
The name of the highlighted input source is displayed.
w Recently used sources
The recently used input sources (up to five) are displayed.
e Icons for the input sources in the different categories are
displayed.
q Press SOURCE SELECT.
Display the “SOURCE SELECT” menu.
w Use uio p to select the input source,
then press ENTER.
The input source is set and the source
selection menu is turned off.
•When using with an iPod connected directly to the USB port of this
unit, select “ (USB/iPod)” for the input source.
•Input sources that are not going to be used can be set ahead of time.
Make this setting at “Source Delete” (vm page 115).
•To turn off the source selection menu without selecting an input
source, press SOURCE SELECT again.
•When SOURCE SELECT is pressed, the AMP-operation mode starts
automatically (vm page 120).
Selecting the input source

Denon AVR-3312 Specifications

General

Impedance	8 Ω
Receiver type	Surround
Frequency range	10 - 100000 Hz
Speaker selector	A+B
Input sensitivity	200 mV
Pre-out connectivity	Yes
Audio output channels	7.1 channels
Audio A/D Converter (ADC)	24-bit/96kHz
Signal-to-Noise Ratio (SNR)	102 dB
Total Harmonic Distortion (THD)	0.8 %
Power output per channel (1KHz@8 Ohm)	165 W
Power output per channel (20-20KHz@8 Ohm)	125 W
HDMI in	7
Audio (L/R) in	8
Composite video in	5
Ethernet LAN (RJ-45) ports	1
Multichannel audio input type	RCA
Component video (YPbPr/YCbCr) in	2
Composite video out	3
Headphone connectivity	6.3 mm
Connectivity technology	Wired
Speakers connectivity type	Binding post
Audio formats supported	AAC, FLAC, MP3, WAV, WMA
Image formats supported	JPG
Wi-Fi	No
AM band range	522 - 1611 kHz
FM band range	87.5 - 108 MHz
Supported radio bands	AM, FM
Preset stations quantity	56
Internet radio services supported	Last.fm, Napster
Supported video modes	1080i, 1080p, 480i, 480p, 576i, 576p, 720p
Display	VFL
HDMI version	1.4a
Product color	Black
Audio decoders	Dolby Pro Logic IIz, Dolby TrueHD, DTS-HD Master Audio
Volume control	Rotary
Apple docking compatibility	iPad, iPhone, iPod
Number of products included	1 pc(s)
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.1 W
Power consumption (typical)	670 W
Card reader integrated	-
Cables included	AC

Weight and Dimensions

Depth	382 mm
Width	434 mm
Height	167 mm
Weight	11800 g