o
Operations cannot be performed through the remote control unit
Symptom Cause / Solution Page
Operations cannot be
performed through the
remote control unit.
0
Batteries are worn out. Replace with new batteries. 15
0
Operate the remote control unit within a distance of about 23 ft/7 m from this unit and at an angle of within
30°.
16
0
Remove any obstacle between this unit and the remote control unit. －
0
Insert the batteries in the proper direction, checking the F and G marks.
15
0
The set’s remote control sensor is exposed to strong light (direct sunlight, inverter type fluorescent bulb
light, etc.). Move the set to a place in which the remote control sensor will not be exposed to strong light.
－
0
When using a 3D video device, the remote control unit of this unit may not function due to effects of
wireless communications between units (such as TV and glasses for 3D viewing). In this case, adjust the
direction of units with the 3D communications function and their distance to ensure they do not affect
operations from the remote control unit of this unit.
－
o
The Bluetooth device names are not displayed properly
Symptom Cause / Solution Page
The device names are not
displayed properly (“…”,
etc.).
0
Characters that cannot be displayed have been used. On this unit, characters that cannot be displayed
are replaced with a “.” (period).
－
0
The device address is displayed when the device name cannot be obtained. －
Contents Connections Playback
Setting procedure
Tips Appendix
57
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
Weight and Dimensions
