Make sure to initialize this unit after replacing the microcomputer or any peripheral equipment, or the
PCB.
1. Press the power operation button to turn off the power, and remove the AC plug from the socket.
2. Press and hold the "
POWER
" button while inserting the AC plug, then continue pressing the "POWER"
button for 8-13 seconds.
Release button "
POWER
" when the power indicator turns white.
4. All lights on the display illuminate for 2 seconds.
5. All lights on the display turn off for 2 seconds.
6. All of the indicators illuminate for 4 seconds.
7. "
Factory Reset
" is shown on the display for 5 seconds.
The settings for the Installer Setup is also initialized.
Network function settings are not initialized.
NOTE： • If the unit fails to enter the service mode in step 7, repeat the procedure from step 1.
• Initializing the device restores the customized settings to the factory settings. Write down
your settings in advance and recongure the settings after initialization.
Use network initialization mode to initialize the network related settings.
1. Press the power operation button to turn off the power, and remove the AC plug from the socket.
2. Press and hold the "
POWER
" button while inserting the AC plug, then continue pressing the "POWER"
button for 3-8 seconds.
3. Release the "
POWER
" button when the Power indicator turns orange and the Eject indicator turns
white.
4. Once "Special model" is displayed, press "
CURSOR
f
", select "Initialize" then press the "Enter"
button.
5. All lights on the display turn off for 5 seconds.
6. "
Initialized
" is shown on the display for 5 seconds.
・All settings, including network function settings, are initialized.
7. "
Initialized
" is displayed and the power turns off 90 seconds later.
(The network device is started and initialized during this time.)
GTop panelH
GFront panelH
BACK
X 5
ENTER
Initializing this Unit
POST-SERVICE PRECAUTIONS
Before Servicing
This Unit
Electrical Mechanical Repair Information Updating
7
To Next Page
Loading...
Need help?
General
