Denon UDR-F10 User Manual

[11] RECORDING CASSETTE TAPES
Cassette deck (UDR-Fi0)
-BBBS?*.
meee
© Before recording on a cassette tape, check that its accidenta! erasure protection tabs are intact
Recording is not possible if the tabs are broken off.
@ The positions of the VOLUME, TREBLE and BASS controls on the pre-main amplifier do not affect the recording.
The fl mark indicates operations which can also be performed on the remote control unit.
: OPEN/CLOSE
Press the OPEN/CLOSE button
and load the tape anto which
you want to record in th
cassette tray. :
Refer to Page 16.
7he mode changes as
foltows each time
Press the DOLBY NR button the button is pressed:
display the Doiby mode.
Refer to Page 8.
To record in Dolby NR, set to
“B" or “C"
ic
_. | To record from the component
To record the radio connected to the AUX terminats To record a CD
Press the FUNCTION button Load the disc in the CD
on the pre-main amplifier player.
to select “MD/AUX”. Refer to Page 20.
Press the tuner’s
BAND selector
button.
BAND FUNCTION
Sy, SS
Tune in the station] Starting playback on the MD
to be recorded. player, video deck or LD
Refer to Page 10. | player.
Ri
Press the CD player's play
button to start playback.
REG:
REC MUTE
<Y
Press the REC/REC
MUTE button The recording pause mode is set and the recording
indicator (@) appears on the display.
AEC LEVEL
The recording jeve! of the source being played is
Adjust the recording displayed on the level meter.
fevel. Use the REC LEVEL control to adjust the recording level.
(Refer to “Adjusting the REC LEVEL Controi” below.)
MIN
Press the play button (DP).
® For synchronized recording of CDs
(Recording starts.)
Press the stop buttons on the
CD player and cassette deck,
then press the CD SRS
button.
CO 3RS
%<Yy
“CD SRS” appears on the display.
(Recording starts.)
* When the CD SRS button is pressed, a blank section
of 9 seconds is automatically created on the tape
before actual recording starts.
To stop recording, press the stop button (
e lf the CD player's play button is pressed in the recording pause mode, recording of the CD begins automatically.
¢ The CD SRS function will not work if the CD player is set to the random ptay or program mode.
Adjusting the REC LEVEL Control
The recorded sound will be distorted if the recording level is too high, or there will be much noise if the recording level is too
low. It is important to set the recording level to an appropriate setting to achieve a good quality recording.
® Watch how far the level meter lights and adjust the REC LEVEL control accordingly.
The recording indicator {@) appears on the
display.
Optimum recording input level (approximate)
Type-I (normal) tapes: | Meter lights up to 0dB
Type-II (CrO2} tapes: | Meter lights up to +1dB
Type-IV (metal) tapes: | Meter lights up to +3dB
NOTE:
The actual recording level differs depending on the
source and the type of tape, so make a trial recording
first to check the recording level.
19
G)
\m
=
m
a
>
=
”
m
i?)
=
oe)
2

Denon UDR-F10 Specifications

General

Brand	Denon
Model	UDR-F10
Category	Stereo System
Language	English