OPERATION LBB Series Oven Owner’s Manual
32 Version 20
5.4. Working with the Control Instrument
Danger!
Failure to heed warnings in this instruction manual and on the
oven could result in personal injury, property damage or death.
The LBB Series oven is factory tested and the controls have been factory-set for normal operating
conditions.
In most applications it is not necessary to alter the oven’s
settings, except for Setpoint.
This section contains information for changing setpoints, programming modes, and displaying
temperature, along with instructions for oven zone calibration, parameter setup mode and
troubleshooting.
5.4.1. Change Setpoint
Warning!
Never operate oven at a temperature in excess of the maximum
operating temperature of 204°C (400°F).
To enter Setpoint on the Control instrument:
1. Press . SP will light.
2. Use ▲ and ▼ to set the operating temperature.
a. The right decimal point LED will flash indicating the Setpoint is being changed.
b. The right decimal point LED stops flashing when the new value has been entered.
3. Press to enter the Setpoint.
4. Press again to display the process temperature.
To Next Page
Loading...
Need help?
General
