ENGLISH
23
SPECIFICATIONS
D25892
AR B2C B3 B2 BR
Voltage 220 V 220 V 120 V 220 V 127 V
Frequency 50 Hz 50 Hz 60 Hz 50–60 Hz 60 Hz
Power 1700 W
Impact Energy 19,4 J (14,3 ft/lbs)
Impact per Minute 1105–2210 ipm
Weight 10,0 kg (22 lbs)
TROUBLESHOOTING GUIDE
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
For assistance with your product, visit our website at www.dewalt.com for a list of servicecenters.
PROBLEM POSSIBLE CAUSE SOLUTION
Tool will not start. The extension cord and/or plug is defective. Have the extension cord and/or plug checked by a qualified
electrician and replaced if necessary.
Internal componets too hot. Allow tool to cool down.
Brushes worn out. Have brushes replaced by an authorized D
WALT service center.
Reduced Power. The extension cord is too long and/or its gauge
is inadequate.
Use an extension cord of an approved length and/or of
adequate gauge.
The speed dial is set to a lower setting. Rotate the speed dial to a higher setting suitable for the application.
The voltage provided by the electric supply
is inadequate.
Connect the hammer to an adequate electric supply.
The chisel cannot be released. The chuck is not pulled back fully. Pull the chuck back as far as it will go and remove the chisel. Refer
to Inserting and Removing SDS MAX Chisels.
To Next Page
Loading...
Need help?
General
