ENGLISH
12
BEVEL CUTS
• Set the required bevel angle.
• Proceed as for ripping.
CROSS-CUTTING (FIG. A, Q1, Q2, R2, U)
• Set the bevel angle to 0°.
• Adjust the saw blade height.
• Set the fence for crosscutting.
• Hold the workpiece (90) flat on the table and
against the fence (73). Keep the workpiece
approx. 25 mm away from the saw blade.
• Keep both hands away from the path of the
saw blade.
• Switch the machine on and allow the saw blade
to reach full speed.
• Hold the workpiece tightly against the fence
and slowly move the workpiece together with
the fence assembly until the workpiece comes
underneath the upper blade guard. Allow the
teeth to cut, and do not force the workpiece
through the saw blade. The saw blade speed
should be kept constant.
• After completing the cut, switch the machine
off, allow the saw blade to stop and remove the
workpiece.
BEVEL CROSS-CUTTING
• Set the required bevel angle.
• Proceed as for cross-cutting.
MITRE CUTS (FIG. R3)
• Set the fence to the required angle.
• Proceed as for cross-cutting.
COMPOUND MITRE
This cut is a combination of a bevel and a mitre cut.
• Set the required bevel angle.
• Set the fence to the required angle.
• Proceed as for a mitre cut.
Dust Extraction
The machine is provided with a 28 mm dust
extraction port on the upper blade guard and a
100 mm dust spout on the side of the fixed guard.
• Connect a suitable dust extraction device during
all sawing operations.
• Whenever possible, connect a dust extraction
device designed in accordance with the
relevant regulations regarding dust emission.
MAINTENANCE
Your DEWALT power tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-ups or
when making repairs.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
WARNING:
• Regularly clean the table top.
• Regularly clean the fence assembly.
• Regularly clean the dust collection
system.
Optional Accessories
WARNING: Since accessories, other
than those offered by DEWALT, have
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only DEWALT recommended
accessories should be used with this
product.
To Next Page
Loading...
Need help?
General
