DeWalt DCH273 Original Instructions

11
ENGLISH
2. For long storage, it is recommended to store a
fully charged battery pack in a cool, dry place
out of the charger for optimalresults.
NOTE: Battery packs should not be stored
completely depleted of charge. The battery pack will
need to be recharged beforeuse.
Labels on Charger and Battery Pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack may
show the following pictographs:
Read instruction manual before use.
See Technical Data for charging time.
Battery charging.
Battery charged.
Battery defective.
Hot/cold pack delay.
Do not probe with conductive objects.
Do not charge damaged battery packs.
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4 ˚C and 40 ˚C.
Only for indoor use.
Discard the battery pack with due care
for the environment.
Charge DEWALT battery packs only with
designated DEWALT chargers. Charging
battery packs other than the designated
DEWALT batteries with a DEWALT
charger may make them burst or lead to
other dangerous situations.
of Dangerous Goods by Road (ADR). Lithium-ion
cells and batteries have been tested to section 38.3
of the UN Recommendations on the Transport of
Dangerous Goods Manual of Tests andCriteria.
In most instances, shipping a D
EWALT battery pack
will be excepted from being classified as a fully
regulated Class 9 Hazardous material. In general, the
two instances that require shipping Class 9 are:
1. Air shipping more than two D
EWALT lithium-ion
battery packs when the package contains only
battery packs (no tools), and
2. Any shipment containing a lithium-ion battery
with an energy rating greater than 100 watt
hours (Wh). All lithium-ion batteries have the
watt hour rating marked on thepack.
Regardless of whether a shipment is
considered excepted or fully regulated, it is the
shipper's responsibility to consult the latest
regulations for packaging, labeling/marking and
documentationrequirements.
Transporting batteries can possibly cause fire if the
battery terminals inadvertently come in contact with
conductive materials. When transporting batteries,
make sure that the battery terminals are protected
and well insulated from materials that could contact
them and cause a shortcircuit.
The information provided in this section of the
manual is provided in good faith and believed to be
accurate at the time the document was created.
However, no warranty, expressed or implied, is
given. It is the buyer’s responsibility to ensure that its
activities comply with the applicableregulations.
Battery Pack
BATTERY TYPE
The DCH143 operates on 14.4 V battery packs. The
DCH243, DCH253, DCH254, DCH273 and DCH274
operate on 18 V batterypacks.
The DCB140, DCB141, DCB142, DCB143,
DCB144 or DCB145 battery packs (14.4 V) may be
used on theDCH143.
The DCB180, DCB181, DCB182, DCB183
DCB183B, DCB184, DCB184B or DCB185
battery packs (18 V) may be used on the DCH243,
DCH253, DCH254 DCH273 andDCH274.
Storage Recommendations
1. The best storage place is one that is cool and
dry away from direct sunlight and excess heat
or cold. For optimum battery performance and
life, store battery packs at room temperature
when not inuse.

DeWalt DCH273 Specifications

General

Brand	DeWalt
Model	DCH273
Category	Rotary Hammer
Language	English