DeWalt DCH273 Original Instructions

15
ENGLISH
• Apply only a gentle pressure to
the tool (approx. 5 kg). Excessive
force does not speed up drilling but
decreases tool performance and may
shorten toollife.
• Do not drill or drive too deep to
prevent damage to the dust cover(o).
• Always hold the tool firmly with both
hands and ensure a secure stance.
Always operate the tool with the side
handle properlymounted.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments
oraccessories.
Proper Hand Position (fi g.1, 6)
WARNING: To reduce the risk of
serious personal injury, ALWAYS
use proper hand position as shown
in figure6.
WARNING: To reduce the risk of
serious personal injury, ALWAYS
hold securely in anticipation of a
suddenreaction.
Proper hand position requires one hand on the
main handle(h), with the other hand on the side
handle(e).
Drill Operation (fi g.1)
WARNING: To reduce the risk of
serious personal injury, turn tool off
and disconnect tool from power
source before making any adjustments
or removing/installing attachments
oraccessories.
WARNING: To reduce the risk of
personal injury, ALWAYS ensure
workpiece is anchored or clamped
firmly. If drilling thin material, use a wood
“back-up” block to prevent damage to
thematerial.
HAMMERDRILLING (FIG.1)
1. Set the mode selector switch(c) to the "rotary
hammering"position.
2. Insert the appropriate drill bit. For best results
use high quality carbide-tippedbits.
3. Adjust the side handle(e) asrequired.
4. Mark the spot where the hole is to bedrilled.
2. Push the keyless chuck(q) onto the spindle and
turn the locking collar into the lockingposition.
3. To replace the keyless chuck with the
SDS Plus
®
tool holder, first remove the keyless
chuck the same way as the SDS Plus
®
tool
holder was removed. Then replace the
SDS Plus
®
tool holder the same way as the
keyless chuck wasreplaced.
WARNING: Never use standard chucks
in the rotary hammeringmode.
Overload Clutch
There are two different types of overload clutch
fitted. The DCH143, DCH243, DCH253 and
DCH254 have a mechanical overload clutch, the
DCH273 and DCH274 have an electronic overload
clutch fitted.
In case of jamming of a drill bit, the drive to the
drill spindle is interrupted. On units fitted with a
mechanical clutch the indication that the clutch has
activated will be an audible ratcheting together with
increased vibration. If the electronic clutch activates
the motor is repeatedly switched on and off for a few
seconds to replicate the feedback associated with a
mechanical clutch. Release and depress the trigger
to re-engage drive.
Because of the resulting forces, always hold the tool
with both hands and take a firmstance.
Dust Extraction System (fi g.1)
A dedicated integrated dust extraction
system (D25303DH) is available and can be
purchasedseparately.
To operate the D25303DH uses an electrical
connection(t) to the rotary hammer.
The DCH253, DCH254 (TYPE 2 Only), DCH273,
and DCH274 rotary hammer models are equipped
with the electrical connection(t).
NOTE: The D25303DH is not compatible with
the DCH143, DCH243 or TYPE 1 versions of the
DCH253 and DCH254.
The DCH274 is available supplied complete with a
D25303DH and extended kit box as the DCH275.
OPERATION
Instructions for Use
WARNING:
• Always observe the safety instructions
and applicableregulations.
• Be aware of the location of pipework
andwiring.

DeWalt DCH273 Specifications

General

Brand	DeWalt
Model	DCH273
Category	Rotary Hammer
Language	English