39
ENGLISH
EC-Declaration of Conformity
Machinery Directive
Cordless Circular Saw
DCS572
declares that these products described under Technical
Data are in compliance with:
2006/42/EC, EN62841-2-1:2015, EN62841-2-5:2014.
These products also comply with Directive 2014/30/EU and
2011/65/EU. For more information, please contact
at
the following address or refer to the back of themanual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of
.
Markus Rompel
Vice President of Engineering, PTE-Europe
, Richard-Klinger-Straße 11,
D-65510, Idstein, Germany
14.10.2019
WARNING: To reduce the risk of injury, read the
instructionmanual.
Definitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to
thesesymbols.
DANGER: Indicates an imminently hazardous
situation which, if not avoided, will result in death or
seriousinjury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or
seriousinjury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderateinjury.
NOTICE: Indicates a practice not related to
personal injury which, if not avoided, may result in
propertydamage.
Denotes risk of electricshock.
Denotes risk offire.
Congratulations!
You have chosen a
tool. Years of experience, thorough
product development and innovation make
one of the
most reliable partners for professional power toolusers.
Technical Data
DCS572
Voltage V
DC
18
Type 1
Battery type Li-Ion
No-load speed min
-1
5500
Blade diameter mm
184
Maximum depth of cut mm
58
Blade bore
mm
16
(-XE: 20 mm)
Bevel angle adjustment °
57
Weight (without battery pack) kg 3.6
Noise values and/or vibration values (triax vector sum) according to EN62841-2-5
L
PA
(emission sound pressure level) dB(A) 91
L
WA
(sound power level) dB(A) 102
K (uncertainty for the given sound level) dB(A) 3
Vibration emission value a
h, W
= m/s
2
<2.5
Uncertainty K = m/s
2
1.5
The vibration and/or noise emission level given in this
information sheet has been measured in accordance with
a standardised test given in EN62841 and may be used to
compare one tool with another. It may be used for a preliminary
assessment ofexposure.
WARNING: The declared vibration and/or noise emission
level represents the main applications of the tool. However
if the tool is used for different applications, with different
accessories or poorly maintained, the vibration and/or
noise emission may differ. This may significantly increase
the exposure level over the total workingperiod.
An estimation of the level of exposure to vibration and/
or noise should also take into account the times when the
tool is switched off or when it is running but not actually
doing the job. This may significantly reduce the exposure
level over the total workingperiod.
Identify additional safety measures to protect the
operator from the effects of vibration and/or noise such
as: maintain the tool and the accessories, keep the
hands warm (relevant for vibration), organisation of
workpatterns.
English (original instructions)
184 mm CORDLESS CIRCULAR SAW
DCS572
To Next Page
Loading...
Need help?
General
