AnywhereUSB Installation Guide (90000405 Rev. F) – Page 2
Configuring the Concentrator
For initial configuration, the Concentrator must be connected to the same local area network as the
configuration PC. In order to configure your AnywhereUSB Concentrator:
1. Launch the AnywhereUSB Configuration Utility from the Start menu. The utility
displays a list of discovered AnywhereUSB Concentrators on your local subnet. A new
AnywhereUSB Concentrator will have a default IP address of 0.0.0.0. You must configure
the Concentrator before it can be used on a network.
2. After the AnywhereUSB Configuration Utility has been launched, it will reside in your
system tray. To open the utility, click on the AnywhereUSB icon in the system tray. If you
try to start this utility from the Start menu and it does not launch, check the system tray.
3. You can identify each concentrator by its IP Address. If the Concentrator is unconfigured,
then the serial number can be used for identification.
Unconfigured Concentrators are listed separately. For example, the Concentrator with serial
number SV320F0217 above has not yet been configured.
4. To discover Concentrators on other networks, go to “Configuring Your Host PC” on page 4
or, for more detailed information, go to “Using the Configuration Utility Program” on page
8.
5. Double click on the Concentrator or select the Concentrator and press the Configure
button.
To Next Page
Loading...
Need help?
General
