Digi ConnectPort LTS 16 Command Reference

Introduction Quick reference for configuring features
ConnectPort® LTS Command Reference
6
n ConnectPort LTS 32
n ConnectPort LTS 32 MEI
n ConnectPort LTS 32 W
n ConnectPort LTS 32 MEI W
Quick reference for configuring features
The following table shows common features that can be configured from the command line, and the
commands used to configure each feature. If you are viewing the PDF file of this document, click the
commands in the “Commands” column to go to the command descriptions.
Feature/Task Commands
Alarms set alarm
Autoconnection
(automatically connect a
user to a server or network
device)
set autoconnect
set serial
set tcpserial
Configuration
management/administration
Backup/restore a configuration from a TFTP server on the network:
backup
Update firmware: boot
Reset configuration to factory defaults: revert or boot
action=factory” (see boot)
Reboot the device: boot
Display current configuration
settings in a device
show
Ethernet settings set ethernet
Help on device commands help and ?
Host name for a device
(Specify a name for the
device)
set host
IP address settings set network
Multiple Electrical Interface
(MEI)
set switches
Point to Point Protocol (PPP) set ppp
Port buffering display buffers
set buffer
Port profiles: sets of
preconfigured serial-port
settings for a particular use
set profile

Digi ConnectPort LTS 16 Specifications

General

Brand	Digi
Model	ConnectPort LTS 16
Category	Server
Language	English