Digi ConnectPort LTS 16 User Manual

Configure the device using the ConnectPort LTS web interface Peripheral
Digi ConnectPort LTS User Guide
92
o
Establish connection under one of the following conditions:
o
Always connect and maintain connections: A connection is always available. If a
connection is lost it will be reconnected automatically. This type of connection is most
often used in client/server configurations where this Digi device server is the client.
Note Select this option to enable autoconnect for 3-wire devices.
o
Connect when data is present on the serial line: A connection is made when the
serial port receives data. This type of connection is most often used for terminals and
terminal emulation.
o
Match string: A 1 to 4 character string. This is usually the newline character sequence
but can also be a custom string of 1 to 4 characters.
o
Strip string before sending: Search for the string specified in the Match String field
before sending the data and strip the string from the string from the data before it is
sent to the destination.
o
Connect when DCD(Data Carrier Detect) line goes high: A connection is made
when the serial port's DCD (Data Carrier Detect) signal goes high. This type of
connection is most often used for modems. See the Advanced Serial Settings for the
option to close the connection when the DCD signal goes low.
Note If you are using 8-wire cabling, you must apply the altpin for DCD functionality.
o
Connect when DSR(Data Set Ready) line goes high: A connection is made when
the serial port's DSR (Data Set Ready) signal goes high. See the Advanced Serial
Settings for the option to close the connection when the DSR signal goes low.

Digi ConnectPort LTS 16 Specifications

General

Brand	Digi
Model	ConnectPort LTS 16
Category	Server
Language	English