Command descriptions set profile
ConnectPort® LTS Command Reference
96
set profile
Purpose
Associates a particular port with one of several port configuration profiles, or displays the current
port-profile settings.
Port profiles are a defined set of port configuration settings for a particular use. A port profile
reconfigures serial-port settings to the necessary default values in order for the profile to operate
correctly.
Port-profile configuration is most often performed through the Web user interface for a device. It is
not often specified from the command line, but is available if needed.
ConnectPort LTS devices support several port profiles. Following is the complete set of port profiles.
The profiles supported on your product may vary.
n Console Management profile: Allows you to access a device’s console port over a network
connection.
n Modem Emulation profile: Allows you to configure the serial port to act as a modem.
n RealPort profile: Allows you to map a COM or TTY port to the serial port.
n TCP Sockets profile: Allows a serial device to communicate over a TCP network.
n Tunneling profile, also known as the Serial Bridge profile: Configures one side of a serial
bridge. A bridge connects two serial devices over the network, as if they were connected with a
serial cable.
n UDP Sockets profile: Allows a serial device to communicate using UDP.
n Custom profile: An advanced option to allow full configuration of the serial port. This profile
allows you to view all settings associated with the serial port.
n Local Configuration profile: The Local Configuration profile allows access to the command-
line interface when connecting from a serial terminal.
n Printer profile: This profile allows you to connect a printer to the serial port
n Modem profile: This profile allows you to connect a modem to the serial port in order to
establish or receive connections from other systems and modems
Required permissions
For products with two or more users, to use this command, permissions must be set to one of the
following:
n For a user to display the profile settings for the line on which they are logged in: “set
permissions s-profile=r-self”
n For a user to display the profile settings for any line: “set permissions s-profile=read”
n For a user to display and set the profile settings for the line on which they are logged in: “set
permissions s-profile=rw-self”
To Next Page
Loading...
Need help?
General