Digi ConnectPort TS 8 User Manual

Digi Connect and ConnectPort TS Family command-line
interface
Management through the command line
interface
Digi Connect Family and ConnectPort TS Family
118
n Current UDP listeners (display udp).
n Uptime information (display uptime).
exit and quit
Use the exit and quit commands to terminate a currently active session.
info
Use the info commands to display statistical information about a device over time. The statistics
displayed are those gathered since the tables containing the statistics were last cleared. The type of
statistics include:
n Device statistics. The info device command displays such details as product, MAC address,
boot, POST, and firmware versions, memory usage, utilization, and uptime.
n Ethernet statistics. The info ethernet command displays statistics regarding the Ethernet
interface, including:
l The number of bytes and packets sent and received
l The number of incoming and outgoing bytes that were discarded or that contained errors
l The number of Rx overruns
l The number of times the transmitter was reset
l The number of incoming bytes when the protocol was unknown
n ICMP statistics. The info icmp command displays the number of messages, bad messages, and
destination unreachable messages received.
n Serial statistics. The info serial command displays the following information:
l Number of bytes received and transmitted
l Signal changes
l FIFO and buffer overruns
l Framing and parity errors
l Breaks detected
n TCP statistics. The info tcp command displays the following information:
l The number of segments received or sent
l The number of active and passive opens
l The number of bad segments received
l The number of failed connection attempts
l The number of segments retransmitted
l The number of established connections that were reset

Digi ConnectPort TS 8 Specifications

General

Brand	Digi
Model	ConnectPort TS 8
Category	Switch
Language	English