DigiTech BASS SYNTH WAH User Manual

Battery Replacement
1. Using the tip of a 1/4” cable, push one of the release pins in on
either side of the pedal, and remove the pedal from the pedal
chassis.
2. Remove the battery from the battery compartment and
disconnect the battery cable.
3. Connect a new battery to the battery cable and put it back in the
battery compartment. Make sure the battery cable does not
interfere with the spring or pedal switch arm.
4. Place one hole of the pedal over its corresponding pin.
5. Push the opposite pin in and lower the other side of the pedal
into place over the depressed pin. Release the pin. When the
pedal is properly fastened, both release pins are flush with the
outer side of the pedal.

DigiTech BASS SYNTH WAH Specifications

Power

power supply	9V Alkaline Dry Battery
power consumption	4.8 Watts
optional power supply	PS200R - 100 (100V ~ 50/60Hz), 120 (120V ~ 60Hz), 230 (230V ~ 50Hz), 240 (240V ~ 50Hz)

Electrical Specifications

input impedance	1 MOhms
output impedance	100 Ohms
battery life	Approximately 4 hours (with continuous usage)

Weight and Dimensions

dimensions	4 15/16” (L) x 3 1/8” (W) x 2 1/8” (H)
weight	1.38 lbs