DigiTech DEATHMETAL User Manual

Battery Replacement
1. Using the tip of a 1/4” guitar cable, push one of the release pins in on
either side of the pedal, and remove the pedal from the pedal chassis.
2. Remove the battery from the battery compartment and disconnect
the battery cable.
3. Connect a new battery to the battery cable and put it back in the
battery compartment. Make sure the battery cable does not interfere
with the spring or pedal switch arm.
4. Place one hole of the pedal over its corresponding pin.
5. Push the opposite pin in and lower the other side of the pedal into
place over the depressed pin. Release the pin. When the pedal is
properly fastened, both released pins are flush with the outer side of
the pedal.

DigiTech DEATHMETAL Specifications

Power

power supply	9V Alkaline Dry Battery
current draw	21mA (at 9VDC)
power consumption	4.8 Watts (w/optional PS200R power supply)
battery life	approximately 18 hours

Electrical Specifications

input impedance	1 MOhms
output impedance	100 Ohms
optional power supply PS200R - 100	100V ~ 50/60Hz
optional power supply PS200R - 120	120V ~ 60Hz
optional power supply PS200R - 230	230V ~ 50Hz
optional power supply PS200R - 240	240V ~ 50Hz

Weight and Dimensions

dimensions	4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H)
weight	1.38 lbs