DigiTech iPB-10 User Manual

38
Configuring the Amp Loop
1. If the Pedalboard window is not already acve, select
it by touching the Pedalboard icon.
2. Touch the Edit buon to display the Edit screen.
3. If there is no amplier assigned, touch the
icon
located in the amp eld. If there is already an amp
assigned, jump to step 6.
4. Select an amplier from the list. The matching cabinet
will be loaded with the amp.
5. Touch the Done buon.
6. To posion where the amp is located in the signal
path, touch the Amp icon and drag it to the desired
posion (this will also set the signal path locaon of
the Amp Loop).
7. Once complete, touch the Performance buon to get
back to Performance mode.
8. Press the AMP LOOP footswitch to engage and
disengage the Amp Loop. When this footswitch LED is
on, the Amp Loop is enabled and the connected device
is inserted into the iPB-10 signal path replacing the
internal amp.
NOTE: If enabled, the Amp Loop connecon remains acve when a tone is bypassed.
1.
2.
5.
3.
4.
8.
7.
6.
Assigning FootswitchesAssigning Footswitches

DigiTech iPB-10 Specifications

General

Brand	DigiTech
Model	iPB-10
Category	Music Pedal
Language	English