71
If you experience a problem with the iPB-10 hardware, you can try performing the factory hard reset procedure listed below.
iPad Connected
1. Turn o the power to the iPB-10 processor by pressing the Power Switch on the back panel.
2. Press and hold
Footswitch A then power on the iPB-10 – keep Footswitch A held down unl you see ‘Fr’ in the LED
display, then release.
3. Press and hold
Footswitch A again unl the display reads ‘rS’, then release.
4. Wait for the processor to go through its sequence. When the reset is complete, the iPad will resync all presets with the
iPB-10 hardware.
5. Once preset sync is complete, the iPB-10 Expression Pedal will need calibraon. Follow the
On-Screen Instrucons
to calibrate the Expression Pedal.
iPad Disconnected
1. Turn o the power to the iPB-10 processor by pressing the Power Switch on the back panel.
2. Press and hold
Footswitch A then power on the iPB-10 – keep Footswitch A held down unl you see ‘Fr’ in the LED
display, then release.
3. Press and hold
Footswitch A again unl the display reads ‘rS’, then release.
4. Aer a few moments, ‘Td’ will appear in the display and the Footswitch 5 LED will begin ashing. Rock the
Expression Pedal completely forward (toe down) then press Footswitch 5.
5. When ‘tU’ appears in the display, rock the
Expression Pedal completely back (toe up) and press Footswitch 5.
6. A numeric value will now appear in the LED display indicang the Expression Pedal V-Switch sensivity. Press rmly on
the
Expression Pedal Toe. Use the Bank Up and Bank Down Footswitches to ne tune the V-Switch sensivity.
7. Press
Footswitch 5 to complete the procedure.
8. Once the iPad is reconnected, it will sync and reassign all factory tones back to the iPB-10 footswitches.
WARNING! Performing the factory hard reset procedure will restore the iPB-10 tones to their
factory state. Aer performing a factory hard reset, you can connect the iPad and launch the
iPB-Nexus app to restore your previous sengs.
To Next Page
Loading...
Need help?
General
