32
The JamMan
®
Delay’s delay time can be synchronized with the Looper’s
tempo. This is an extremely useful feature that allows the delay time to be
automatically set based on the tempo of any loop that is playing.
To enable Delay Tempo synchronization, follow these steps:
Press and hold the 1. DELAY TEMPO footswitch for 2 seconds until its LED
stops flashing and lights solid red (this indicates Delay Tempo Sync
mode).
You can now use the looper’s 2. TEMPO/STOP footswitch to tap in the
tempo for both the loop and the delay.
When Delay Tempo Sync mode is active, you can change loops and the delay
Tempo will automatically be set to the loop’s tempo. This ensures your delay
time will always be synced with the loop that is playing. To exit Delay Tempo
Sync mode, simply tap the delay Tempo footswitch once or turn the Time knob.
Another feature that can be used when Delay Tempo Sync is enabled is a
6th Multiplier. While Sync is enabled, press the MULTIPLIER button until all
MULTIPLIER LEDs light. In this state, the delay time will match the length
of the loop phrase up to 16 seconds. If the loop phrase is longer than 16
seconds, the delay time will divide in half as needed to match the loop length.
NOTE: Delay Tempo Sync only works with the active delay memory. If a
different delay memory is selected, Delay Tempo Sync will be defeated and
need to be re-enabled.
Synchronizing Delay Tempo to
Loop Tempo
To Next Page
Loading...
Need help?
General
