To Next Page

To Previous Page

Formatting SD Cards

Although it may not be mandatory, it is recommended any memory card that is

inserted into the JamMan

Delay for the ﬁrst time should be formatted using the

JamMan Delay’s format procedure. To format an SD/SDHC Card in the JamMan

Delay, follow these steps:

Insert an optional SD/SDHC card in the 1. MEMORY CARD slot on the

rear panel.

Press and hold the 2. LOOP STORE button for six seconds. The display will show

FO (Format) and the LOOP STORE button will begin ﬂashing.

Press the 3. LOOP STORE button again. The DISPLAY will read F? (Format ?) and

the LOOP STORE button will continue to ﬂash. To abort this procedure, press

the SETUP button.

To initiate the card formatting procedure, press and hold the 4. LOOP STORE

button for two seconds. The DISPLAY will show Bu indicating the card is

being formatted.

NOTE: When using a new SD/SDHC card, it is recommended that you

format it using the procedure outlined above before using it with the

JamMan Delay.

Unformatted Cards

If a memory card is inserted into the JamMan Delay that does not have a valid format,

the JamMan Delay will not recognize it and the DISPLAY will read nF. The card must be

formatted before the JamMan Delay can use it. To format the card, follow these steps:

While the 1. DISPLAY reads nF, the STORE button will begin ﬂashing prompting

for a format conﬁrmation.

Press the ﬂashing 2. LOOP STORE button. The DISPLAY will read F? and the

LOOP STORE button will continue to ﬂash. You can press the SETUP button

to abort the procedure.

To initiate the card formatting procedure, press and hold the 3. LOOP STORE

button for two seconds. The DISPLAY will show Bu indicating the card is

being formatted. Once completed, the DISPLAY will read 1 and the card is

now ready for recording.

Using Optional SD/SDHC Memory Cards

DigiTech JAMMAN User Manual

Other manuals for DigiTech JAMMAN