memorized target icon and other target icons will be removed. In this case the
detector will only detect 1cent coin and will have no response to other metal
targets.
(4) JEWELRY Mode
Press MODE to select JEWELRY. JEWELRY is displayed on LCD. This means
JEWELRY mode is selected.
The JEWELRY mode is designed to find jewelry such as rings, bracelets,
necklaces. It also can find coins, relics and other non-jewelry items. It
ignores most nails and small iron pieces automatically. Iron target ID will not
appear on LCD. In this mode, the detector will not respond to iron. If you
don’t want to detect iron, you can use JEWELRY mode for detection.
Step 3. Adjusting sensitivity
Press SENS, then + or – to increase or decrease the sensitivity.
Step 4. Place the detector on a wooden or plastic table, then remove any watches,
rings, or metal jewelry you are wearing.
Step 5. Adjust the search coil so the flat part points towards the ceiling.
Note:
Never test the detector on a floor inside a building. Most buildings have
metal of some kind in the floor, which might interfere with the objects
you’re testing or mask the signal completely.
To Next Page
Loading...
Need help?
General