24
Harmony Pitch Shifting ()
Harmony Pitch Shifting makes a copy of the incoming signal, and then changes the pitch of the
copied note to a diatonically correct interval specified by the Amount parameter. A Harmony
Pitch Shifter sharpens or flattens the shifted pitch in order to keep the specified interval within
the selected key and scale creating a true harmony.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
ShiftAmount-Knob3 selects the amount or harmony interval for the Intelligent Pitch
Shifter. Interval choices include:
(octave down)
(a seventh below)
(a sixth below)
(a fifth below)
(a fourth below)
(a third below)
(a second below)
(a second above)
(a third above)
(a fourth above)
(a fifth above)
(a sixth above)
(a seventh above)
(an octave above)
Key - Knob 4 selects the musical key that the Harmony Pitch Shifting uses. Key choices
range from the Key of E () through the Key of E ().
Scale - Knob 5 selects the scale the Harmony Pitch Shifting will use. Scale choices include:
Major (), Minor (), Dorian (), Mixolydian (), Lydian (
), and Harmonic Minor ().
Level - Knob 6 adjusts the Harmony Pitch Shifting Level of all the pitch-altering effects in
this module. Ranges from to .
Boss
®
OC-2 Octaver
TM
()
Based on the Boss
®
OC-2 Octaver
TM
, this model adds two signals to your original guitar signal.
The first is one octave below your guitar, and the second is two octaves below your guitar. Each
additional signal has its own volume control.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Octave 1- Knob3 adjusts the the volume of the signal 1 octave below the input signal.
Ranges from to .
Octave 2 - Knob 4 controls the volume of the signal 2 octaves below the input signal.
Ranges to .
Dry Level - Knob 6 controls the volume of the dry signal. Ranges from to .
Delay
Delay is an effect that records a portion of the incoming signal, and then plays it back a short
time later. The recording can repeat just once or several times.
Delay Model - Knob 1 selects one of the 7 different Delay models. Values include:
(DigiTech
®
Analog Delay), (Based on the Boss DM-2 Analog Delay),
(DigiTech Digital Delay), (DigiTech Modulated Delay), (DigiTech
Pong Delay), (DigiTech Tape Delay), and (Based on the Maestro
TM
EP-2
Echoplex
®
Tape Echo). Press this knob to turn the Delay models on and off.
To Next Page
Loading...
Need help?
General
