13
ACTIVATING ALARM FUNCTION
1. In normal mode, press the [ MODE / ALARM ] key to show
the alarm time for 5 seconds.
2. When the alarm time displays, press the [
MODE / ALARM ]
key again to activate the alarm function.
Alarm o Alarm on
When the clock reaches the alarm time, the alarm sound will start.
Where it can be stopped by the following operation:
- Auto-stop after 2 minutes of
alarming if without any operation and the alarm will activate again on
the next day.
- By pressing the [ ALARM / SNOOZE ] key to enter snooze, the alarm will sound again after 5
minutes.
- By pressing and hold the [ ALARM / SNOOZE ] key for 2 seconds to stop the alarm and it will
activate again in the next day
- By pressing [ MODE / ALARM ] key to stop the alarm and the alarm will activate again on the
next day.
NOTE:
- The snooze could be used continuously for 24 hours.
- During the snooze, the alarm icon “
” will keep ashing.
WIRELESS SENSOR SIGNAL RECEIVING
1. The console display signal strength for the wireless sensor(s), as per table below:
Signal strength of wireless
sensor channel
No signal Weak signal Good signal
2. If the signal has discontinued and does not recover within 15 minutes, the signal icon will
disappear. The temperature and humidity will display “Er” for the corresponding channel.
3. If the signal does not recover within 48 hours, the “Er” display will become permanent. You
need to replace the batteries and then press the [ SENSOR
/ WI-FI ] key to pair up the
sensor again.
VIEW THE OTHER CHANNELS (OPTIONAL FEATURE WITH ADD ON EXTRA SENSORS)
This console is capable to pair with 7 wireless sensors. If you have 2 or more wireless sensors,
you can press the [ CHANNEL ] key to switch between different wireless channels in normal
mode, or press and hold the [ CHANNEL ] key for 2 seconds to toggle auto-cycle mode to
display the connected channels at a 4 second interval.
During auto-cycle mode, the icon will show on the wireless sensor channels section of the
console's display. Press the [ CHANNEL ] key to stop the auto cycle and display the current
channel.
TEMPERATURE / HUMIDITY FUNCTION
- The temperature and humidity readings are displayed on the channel and indoor section.
- Use the [ °C / °F ] key to select the temperature display unit.
- If the temperature / humidity is below the measurement range, the reading will show “LO”. If the
temperature / humidity is above the measurement range, the reading will show “HI”.
COMFORT INDICATION
The comfort indication is a pictorial indication
based on indoor air temperature and humidity in
an attempt to determine comfort level.
Too cold Comfortable Too hot
NOTE:
- Comfort indication can vary under the same temperature, depending on the humidity.
- There is no comfort indication when temperature is below 0°C (32°F) or over 60°C (140°F).
To Next Page
Loading...
Need help?
General
