Backhoe - 118 RT80Q Operator’s Manual
Setup
CMW
Setup
1. Move attachment speed/direction control to neutral position.
2. Move ground drive control to neutral position.
3. Engage parking brake if not on level ground.
4. Lower rear attachment to 6” (150 mm) above ground.
5. Check that backfill blade is straight and lower it to ground.
6. Ensure ground drive is in low speed.
7. Decrease engine speed to low throttle.
8. Move to backhoe operator’s station.
9. Release seat lock (shown) and move seat
into operating position.
10. Release and lower stabilizers enough to lift
front tires or tracks.
11. Disengage boom and swing stow locks.
12. Adjust engine speed to 1/2 to 3/4 throttle for
digging.
IMPORTANT: Engine speed affects
speed of backhoe operation.
To Next Page
Loading...
Need help?
General
