RT80Q Operator’s Manual Transport - 93
Tow
CMW
Tow
Under normal conditions, tractor should not be towed. If tractor becomes disabled and towing is
necessary:
• Do not tow for more than 200 yd (180 m).
• Tow at less than 1 mph (1.6 km/h).
• Steering will be very difficult.
Procedure
1. Engage parking brake.
2. Block front and rear tracks to prevent unit
from rolling.
3. Attach tow line to all available tie-down
points facing towing vehicle.
4. Activate the tow valve (shown).
• Under tractor, locate two screws on
bottom of pump housing.
• Use flat blade screwdriver to turn
each screw 90° counterclockwise until
they contact relief check valves.
5. Remove blocks.
6. Fasten seatbelt and adjust seatbelt.
7. Disengage parking brake.
8. After towing, turn tow screws clockwise 90°.
Incorrect procedures could result in death, injury, or property damage.
Learn to use equipment correctly.
t33om076w.eps
To Next Page
Loading...
Need help?
General
