DJI Action 2 User Manual
©
2021 DJI OSMO All Rights Reserved.
8
DO NOT attach the adhesive base to surfaces that are rough, powdered, peeling, covered in dust
or sand, or have oil or water stains. Otherwise, the adapter mount may not be attached rmly.
It is recommended to use the magnetic adapter with the OSMO Action Mounting Kit when recording
during strenuous exercise.
DJI Action 2 Magnetic Ball-Joint Adapter Mount
The DJI Action 2 Magnetic Ball-Joint Adapter Mount can be magnetically attached to the camera unit,
the front touchscreen module, or the power module. Make sure the magnetic lock clips are properly
attached to the magnetic lock holes on the camera unit or module on both sides and press both clips
before removing. Make sure to press the adhesive base for at least 10 seconds after attaching it to a
surface. Otherwise, the adapter mount may not attach rmly. The adhesive base on the bottom of the
adapter mount can be used repeatedly after washing and air drying.
DJI Action 2 Magnetic Adapter Mount
The magnetic adapter mount can be magnetically attached to the camera unit, the front touchscreen
module, or the power module. Make sure the magnetic lock clips are properly attached to the
magnetic lock holes on the camera unit or module on both sides and press both clips before removing.
DO NOT use when wearing thick clothes such as sweaters or jackets. Otherwise, the magnetic
connection may be too weak and the camera unit will fall o.
DO NOT use when performing strenuous exercise such as jumping and running.
Make sure to keep the magnetic sheet of the magnetic lanyard inside the clothing. Otherwise, the
magnetic connection may be too weak and the camera unit will fall o.
Only attach the camera unit to the magnetic lanyard. DO NOT connect any other accessories.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
