DJI RC 2
User Manual
©
2023 DJI All Rights Reserved.
11
Remote Controller Operations
Checking the Battery Level
Press the power button once to check the current battery level.
Powering On/O
Press and then press again and hold to power the remote controller on or o.
Linking the Remote Controller
The remote controller is already linked to the aircraft when purchased together as a combo.
Otherwise, follow the steps below to link the remote controller and the aircraft after activation.
1. Power on the aircraft and the remote controller.
2. Launch DJI Fly.
3. In camera view, tap
and select Control and then Re-pair to Aircraft. During linking, the
status LED of the remote controller blinks blue and the remote controller beeps.
4. Press and hold the power button of the aircraft for more than four seconds. The aircraft
beeps twice after a short beep, and its battery level LEDs blink in sequence to indicate it is
ready to link. The remote controller will beep twice, and its status LED will turn solid green to
indicate linking is successful.
• Make sure the remote controller is within 0.5 m of the aircraft during the linking.
• The remote controller will automatically unlink from an aircraft if a new remote
controller is linked to the same aircraft.
• Turn o Bluetooth and Wi-Fi for optimal video transmission.
HighBatteryLow
To Next Page
Loading...
Need help?
General
