DJI RC Plus User Manual
14
©
2023 DJI All Rights Reserved.
2. Run DJI Pilot 2 and tap Link Remote Controller to link. The status LED of the remote controller will
blink blue, and the remote controller will beep during linking.
3. Press and hold the power button on the aircraft for at least ve seconds. The aircraft power indicator
will blink and will beep twice to indicate linking has started. When linking is successful, the aircraft
rear indicators will blink green while the remote controller will beep twice, and the remote controller
status LEDs will turn solid green.
Make sure the remote controller is within 50cm (1.6ft) of the aircraft during linking.
Make sure the remote controller is connected to the internet when logging in using a DJI account.
To Next Page
Loading...
Need help?
General
