26
C. Return Air Housing
1. Clean housing with a soft cloth dampened with water and a mild detergent.
NEVER use furniture polish, solvents, scouring pads or powders.
D. Fan Motor
1. The blower motor is factory lubricated and requires no service.
SERVICE-UNIT DOES NOT OPERATE
In the unlikely event the unit fails to operate or operates improperly, check the following before calling your
service center.
● If the RV is connected to a motor generator, make sure the motor generator is running and
producing power.
● If the RV is connected to a power supply by a land line, make sure the line is sized properly to
run unit load and that it is plugged into the power supply.
● Check the 120 Vac fuse or circuit breaker. Make sure the fuse is not burnt or that the circuit
breaker is “ON” and not activated.
● Check the 12 Vdc fuse or circuit breaker. Make sure the fuse is not burnt or that the circuit
breaker is “ON” and not activated.
After the above checks have been made, and unit still does not operate, please visit www.eDometic.com to
locate a service center near you. This product MUST be serviced by a qualied service technician. When
contacting a service center, always give the following:
● Unit model and serial number. This information can be found on the identication label located
on the unit base pan. Remove the return air lter to view the identication label.
● Air Distribution Box (if equipped) model and serial number. This information can be found on
the rating plate located on the ceiling template. Remove the return air lter to view the rating
plate.
● Electronic Control Kit (if equipped) part number and serial number. This information can be
found on the identication label located on the side of the electronic control box. Remove the
return air lter to view the identication label.
MAINTENANCE
To Previous Page
Loading...
Need help?
General
