a
Before initial use FreshJet3000
14
6 Before initial use
Inspection before starting up
Before you switch on the roof air conditioner, observe the following:
➤ Check whether the supply voltage and frequency correspond to the values
specified in the technical data (see leaflet).
➤ Ensure both the air intake opening and the air nozzles are free. All ventilation
grilles must always be kept free to ensure that the roof air conditioner is able to
operate at maximum capacity.
!
Set the remote control
➤ Insert the batteries (see chapter “Replacing the remote control batteries” on
page 20).
✓ The display shows all symbols for 5 seconds.
✓ The remote control is ready for operation.
7 Operating the roof air conditioner
7.1 Basic notes on operation
The roof air conditioner has three operating modes:
You can use the control panel to
• switch the roof air conditioner to and from stand-by mode
• switch the ambient lights on and off
CAUTION! Beware of injury
Do not insert your fingers or objects into the air nozzles or the intake
grille.
Operating mode Features
Off The roof air conditioner is switched off.
The remote control is inactive.
Stand-by The roof air conditioning is ready for operation and can be switched
on with the remote control. The ambient lights are available.
On The roof air conditioner is conditioning the air in the interior.
FreshJet3000-OPM.book Seite 14 Donnerstag, 27. Februar 2020 4:17 16
To Next Page
Loading...
Need help?
General
