RML9330 – RML9435 Intended use
17
5 Intended use
The RML9330, RML9331, RML9335, RML9430, RML9431 and RML9435
refrigerators are designed for installation in caravans or motorhomes. They
are only suitable for cooling and storing foodstuffs. The refrigerators are not
intended for the proper storage of medicine.
The refrigerators are designed to be operated on a DC power supply and an
AC socket and can be independently powered by liquid gas (propane or
butane). The refrigerators may not be run on natural gas or city gas.
6 Installing the refrigerator
6.1 Preparing the installation
When installing the refrigerator, note the following:
To enable the refrigerant to circulate properly, the refrigerator may not
exceed an angle of 3 °.
To do this, park the vehicle on a level surface and check to see if the
ice-cube tray is flat in the refrigerator.
The refrigerator must be installed so that it is easily accessible for service
work, easy to de-install and install and can be easily removed from the
vehicle.
The distance between the refrigerator and the rear wall must be at least
20 mm.
The refrigerator must be installed in a recess so that it stands firm when
the vehicle is in motion. Note the following dimensions here (H x W x D in
mm):
– RML9330/9331/9335: 1293 x 420 x 586.5 (fig. 1, page 2)
– RML9430/9431/9435: 1293 x 468 x 553 (fig. 2, page 2)
The outer wall must be fitted with an air inlet vent (fig. 3 1, page 3) and
an outlet vent (fig. 3 2, page 3) with ventilation grilles so that the heat
generated can be easily released to the outside:
– Air inlet vent: Fit the ventilation grille as flush as possible to the floor of
the installation niche with a minimum cross-section of 500 cm².
– Outlet vent: fit as far above the refrigerator as possible.
– The distance between the air inlet and outlet vents must be at least
1050 mm (fig. 4, page 3).
Fit a heat conduction plate (fig. 3 3, page 3) above the refrigerator so
that the heat does not accumulate in the vehicle.
To Next Page
Loading...
Need help?
General
