Operation TCX14, TCX21, TCX35
10
6Operation
I
6.1 Tips to save energy
I
•
Choose a well ventilated location which is protected from direct sunlight.
•
If you want to set an increased energy efficiency and a limited cooling capacity for
the cooler device, use the device’s ECO mode.
•
Allow warm food to cool down first before placing it in the cooling device to
keep cool.
•
Do not open the cooling device more often than necessary.
•
Do not leave the cooling device open for longer than necessary.
6.2 Connecting to vehicle power
I
For safety reasons the cooler is equipped with an electronic system to prevent
polarity reversal. This protects the cooler against short-circuiting when connecting to
a battery.
NOTE
Before you put the new cooling device into operation, you should clean
it inside and outside with a damp cloth for hygienic reasons (see also
chapter “Cleaning and servicing” on page 13).
NOTE
A ventilator in the interior space of the cooling device provides for the
circulation of the cold air within the box. Thus a better cooling capacity
will be achieved. In order that the cold air cannot reach the outside
when opening the cooling device, it is equipped with a switch which
turns off the ventilator as soon as the lid is opened.
NOTE
If you connect the cooling device to the vehicle power, remember that
you may have to turn on the ignition to supply it with power.
TCX14-TCX35-OPM-EMEA16.book Seite 10 Montag, 6. Mai 2019 1:17 13
To Next Page
Loading...
Need help?
General
