Dometic VFS User Manual

8
EN
Flush Controls
7 OPERATION
7.1 Operating VFS, VFP, and VFSHW (4000 Series)
Toilet system startup
➤ Turn ON electrical power and water supply to the toilet.
➤ Flush the toilet five times by pressing the Flush button or waving a hand over the motion
sensor (VFSHW only). Allow each flush cycle to complete until the OK TO FLUSH light
indicates the system is ready for the next flush. This ensures that flush water is present
throughout the entire vacuum system.
10
Normal toilet operation (VFS, VFP, and
VFSHW)
➤ Press and hold the Add Water button
until the desired water level is achieved in
the bowl.
➤ Press the Flush button to flush the toilet.
Do not attempt to flush the toilet when
the red DO NOT FLUSH light is ON.
➤ Press the Add Water button twice quickly
to toggle through backlight modes:
– Always ON (full brightness, default)
– Always ON (dim) (VFSHW only)
– Energy saving (ON when motion is
sensed) (VFSHW only)
– Always OFF
11
Motion
Sensor
Using the hand wave feature (VFSHW
only)
I
The motion sensor range is 4"
(10 cm).
➤ Hold your hand in front of the Motion
Sensor to fill the bowl with water. Water
will start to flow aer three seconds.
Continue to hold your hand in front of the
motion sensor until the desired water level
is achieved.
➤ Wave your hand in front of the Motion
Sensor to flush the toilet. Do not attempt
to flush the toilet when the red DO NOT
FLUSH light is ON.
➤ The handwave function can be toggled
on/off by holding in BOTH the le
and right buttons for 5 seconds. A
backlighting fade sequence will follow
indicating the handwave operation has
been toggled:
– Backlight fade‑to‑on indicates
handwave has been toggled to
‘enabled’.
– Backlight fade‑to‑off indicates
handwave has been toggled to
‘disabled’.

Dometic VFS Specifications

General

Brand	Dometic
Model	VFS
Category	Plumbing Product
Language	English