MODULRAM DIGITAL | Edition A - Revision 0
Instruction Manual | 6
3 | First time heating process (control panel 8090
)
Ramalhos mode
Ft
rA
Oven Function test
Ramalhos mode
Fh
rA
First heating of the oven.
First heating of the oven
Ramalhos mode
“n” corresponds to the present phase
and “6 ” is the number of the rst time
heating programme phase
Fh
rA
n-6
TOP temperature
Remaining time of the corresponding
maintenance or resting phase
STONE temperature
100
15
100
First heating of the oven
Ramalhos mode
End of rst heating process
Fh
rA
End
Heating the oven for the rst time is extremely important
to ensure its future proper functioning and avoid structural
problems. The rst heating programme must be executed
in full and only after it has been completed does the con-
trol panel enter normal operation mode. If there is a power
cut, the programme will restart in the last temperature re-
When the oven is turned on for the rst time it will
automatically enter Ramalhos mode and show
the message: Funtion Test and First Heating on
the display of the control panel. You can use the
and , buttons to select one of the operation op-
tions shown alternately on the display:
1) Function Test:
It is used to check the oven is functioning properly after in-
stallation. During this phase the oven temperature will not
surpass 50º C. To initiate the function test press the but-
ton.
corded with a 25ºC margin. To start this programme press
the button.
+
Note
To return to Ramalhos mode, press the button to
turn the oven o and on again.
–
The whole process will be managed automatically by the
control panel.
Throughout the process the display will alternately show dif-
ferent information, namely:
END OF FIRST HEATING PROCESS
Once all stages of the rst heating programme are complet-
ed the control panel will show the following information:
2) First time heating the oven
Note
The rst heating process may take up to 6 hours.
Finally press , you may now start the baking cycle.
To Next Page
Loading...
Need help?
General
