Storage | en
Instructions for use | X-act
®
7000 21
Information on troubleshooting, see Technical Manual 9300160:
Test Tube Manual:
draeger.com/tubeshandbook
5.2 Cleaning
WARNING
Damage to the device caused by liquids!
Liquids in the device and at the sensors may damage the device.
► Do not immerse the device in any liquid. Do not use any cleaning agents
that contain alcohol, lemon or solvent.
The device will need to be cleaned if one of the following situations arises:
– Contamination of the housing openings (gas inlet, gas outlet and retainer for
Dräger MicroTubes, mini USB port)
– Contamination of the keypad
To clean the device, wipe it down with a damp cloth and, while doing so, wipe
the dirt away from the housing openings.
When cleaning, make sure that no cleaning agent enters the gas inlet.
6 Storage
Store the X-act 7000 carefully, protected against moisture and direct sunlight.
7 Disposal
8 Technical data
Inspection Interval
Inspections and maintenance carried
out by specialists.
Every 12 months
5745857714
This product must not be disposed of as household waste. This is indi-
cated by the adjacent icon.
You can return this product to Dräger free of charge. For information
please contact the national marketing organisations and Dräger.
Batteries must not be disposed of as household waste. They are there-
fore marked with the adjacent symbol. Dispose of batteries and
rechargeable batteries at battery collection centers as specified by the
applicable regulations.
Ambient conditions
Operation:
Temperature -20 °C to +50 °C (-4 °F to +122 °F)
Air pressure 700 hPa to 1300 hPa
Relative humidity 0 to 95 % RH (non-condensing)
Storage:
Temperature -20 °C to +55 °C (-4 °F to +131 °F)
Air pressure 700 hPa to 1300 hPa