43
english deutschfrançaisespañolitaliano
nederlands
9. Abort/termination of programme
The polymerisation process can be ter-
minated prematurely. For this purpose
push the adjustment knob (b) for 3 sec-
onds. The Polymax ventilates automati-
cally, the display for time shows 0, the
pre-adjusted temperature is maintained.
For following polymerisation processes
with identical temperature continue as
described from point 7.2 on.
10. Change between °C and °F
At delivery the Polymax units are
adjusted to °C. In order to change to °F
push the temperature switch (e) and
the main switch (14) at the same time.
The temperature indication display (d)
shows L (which stands for °C), the time
indication display (f) shows the maxi-
mum value of 95. By turning the adjust-
ment knob (b) it is possible to change
between L (°C) and H (°F). When the
machine is adjusted to H the time indi-
cation display shows the value 203.
Exception Polymax (1/120 °C): The time
indication display (f) shows the maxi-
mum values 120 °C or 248 °F. Push
the adjustment knob (b) one time in
order to confirm the selected tempera-
ture denomination. The time and tem-
perature indication displays (d + f) indi-
cate 0. Then go on as described from
point 7 on.
When the time has passed the unit ven-
tilates automatically. The lid of the Poly-
max 1/120 °C can, however, only be
opened, if the temperature of the water
bath has fallen below 95 °C.
If the pressure pot has got a tempera-
ture of more than 95 °C after the time
has run out, it is cooled down by cold
air until the temperature has fallen
below 95 °C. During this time the
cooling air is released by means of the
ventilation valve. When operating at
120 °C the cool down phase can take
5–8 minutes from time expiration to
the opening of the lid.
The possibility of opening the lid is indi-
cated by the green control lamp (h).
Open the lid and remove the objects.
To Next Page
Loading...
Need help?
General
