Chapter 2.0 Understanding Your Keypad
2.0 Understanding Your Keypad
The PowerSeries Neo Alarm System supports a varie ty of wireless, hardwired and proximity
sensor LCD, LED and Icon keypads. All keypads come equipped with the LED status lights
described in section 1 "Quick Reference". HS2LCD series keypads display system messages on
thei r LCD screen. HS2ICN series keypads display messages, as described in the following secti on.
HS2LED series keypads display messages via a series of numbered LEDs, as desc ribe d in the fol-
low ing section. All keypad versions will have a solid blue LED bar that is always on exc ept when,
if e nrolled, a proximity tag is presented and successfully read by the keypad.
2.1 Icon and LED Keypad Symbols
HS2ICN Series HS2LED Series
5
9
6
12 7
10
11
1
8
15
2
3
4
17
16
14
13
5
9
7
6
1. Clock Digits 1, 2 These clock digits indicate the hour when the local clock is active.
Digit 2 is also used to identify t he zone number.
2. : (Colon) This icon is the hours/minutes di vider and will flash once per
second when the local clock is active.
3. Clock Digits 3, 4 These are the minute digits when the local clock is active. The
di gits 3 and 4 are used to indic at e the zone number for open zone s
or alarm in memory. These two digits combined with the clock
di git 2, scroll one zone per second from the lowest number to t he
hi ghest, when scrolling through zones.
4. 1 to 8 These numbers identify troubles when [*][2] is pressed.
5. Memory Indicates that there are alarms in memory.
6. Bypass Indicates that there are zones bypassed.
7. Program Indicates that the system is in Installer or User's programming, or
that the keypad is busy, and the LED will flash. If a n Access
Code is r equired, while accessing [ *] menus, this LED is ON and
solid to indicate that the code is required.
8. Away Indicates that the panel is armed in the Away Mode.
9. Fire Indicates that there are fire and/or CO alarms in memory.
10. Stay Indicates that the panel is armed in the Stay Mode.
11. Chime This icon turns on when the Chime function key is pressed to
e nable Door Chime on the system. It will t urn off when the chime
function key is pressed again to disable Door Chime.
- 5 -
To Next Page
Loading...
Need help?
General
