Dyson AM09 User Manual

6
Power
Heating and cool modesRemote control
Remote control docks magnetically.
Attach the remote control to the top of the
appliance with the buttons facing down.
To operate, point the remote control
toward the front of the base.
Each time the heating mode is selected, it
conducts a short calibration cycle. Airflow will
be automatically controlled during this cycle.
Once the calibration cycle is complete, it will
revert to the selected airflow speed.
Press and hold the power button to
run through the target temperatures.
Cool mode
Press the blue thermostat control button to change the target
temperature to 0°C. The power button light will change
from red to blue. To adjust the airflow speed use the airflow
control button.
Heating mode
Press the red thermostat control button until the digital display
shows the desired target temperature. The power button light
will change from blue to red. The red circle will disappear
when the target temperature has been reached.
Standby
ON/OFF
Airflow speed
control
Sleep timer
Personal
heating
Oscillation
ON/OFF
Diffused
mode
Thermostat
control
Cool
mode
Select the desired room temperature.
Pressing the large red button increases the
target temperature by 1°C; the smaller red
button decreases it by 1°C. The appliance will
not operate in heater mode unless the target
temperature is above the room temperature.
On first use, the appliance will default to a
temperature 3°C higher than the detected
room temperature. Thereafter, the appliance
will remember the last target temperature set.

Dyson AM09 Specifications

General

Brand	Dyson
Model	AM09
Category	Heater
Language	English