Using your High Torque XL cleaner head
Your High Torque XL cleaner head has a slider control to adjust the suction of the cleaner head. To select the
suction required, move the suction control slider on top of the cleaner head.
+
Maximum suction for ground-in dust and debris For vacuuming durable floor coverings, hard floors and heavily soiled
carpets and rugs.
Suction for dust and debris For vacuuming lightly-soiled carpets, rugs and hard flooring. For vacuuming large debris
such as peanuts or rice.
–
Suction for deep pile carpets and delicate flooring For vacuuming deep pile carpets or rugs and flooring where you
experience greater resistance. For vacuuming lightly soiled floors, and delicate flooring such as vinyl, parquet and
lino.
Looking for blockages
Your machine is fitted with an automatic cut-out. If any part becomes blocked, the machine may automatically cut
out. The motor will pulse and the LCD screen will indicate that there is a blockage.
Be careful not to pull the power trigger while looking for blockages.
Make sure any blockages are clear and all parts are refitted before using your machine.
Beware of sharp objects when checking for blockages. Clearing blockages is not covered by your guarantee.
If you can’t clear an obstruction from the cleaner head, you may need to remove the brush bar. Use a coin to unlock
the fastener, slide the brush bar
out of the cleaner head and remove the obstruction. Replace the brush bar and securely tighten the fastener. Make
sure it is fixed firmly before using your machine. Your machine has carbon fiber brushes. Take care if coming into
contact with them, as they may cause minor skin irritation. Wash your hands after
handling the brushes.
To Next Page
Loading...
Need help?
General
