Eaton 93E UPS 15-80 kVA (380/400/415 V) Installation and Operation Manual
© Eaton Corporation plc 2015. All rights reserved. Revision: 001
Document ID: 614-01975-00
13 (133)
CAUTION
Only qualified service personnel knowledgeable of the UPS and battery
systems and the required precautions are allowed to perform
installation or service work on batteries. Keep unauthorized personnel
away from the equipment. Before you install or replace equipment,
consider all the warnings, cautions, and notes concerning appropriate
handling. Before you connect or disconnect batteries, make sure
batteries are not being charged or discharged.
See the installation instructions before you connect the UPS to the
supply.
Make sure that your replacement batteries are of the same number
and type as the battery that was originally installed in the UPS.
Replacing the battery with an incorrect type causes a risk of explosion.
This UPS uses floating battery circuit which must not be grounded.
Dispose of batteries according to your local disposal requirements. Do
not dispose of batteries in a fire. When exposed to flame, batteries
may explode.
To ensure proper cooling airflow and to protect personnel from
dangerous voltages inside the unit, keep the UPS door closed and the
front panels installed.
Do not install or operate the UPS system close to gas or electric heat
sources.
Keep the operating environment within the parameters stated in this
document. Keep the surroundings of the UPS uncluttered, clean, and
free from excess moisture.
Observe all DANGER, CAUTION, and WARNING notices affixed to the
inside and outside of the equipment.
To Next Page
Loading...
Need help?
General
