CS-2511T OPERATION
X7503332503 33
© 11/19 ECHO Incorporated
5. Choke may be used if necessary,
but after first starting sound,
squeeze throttle trigger to
release choke and return engine
to idle.
Note: If engine does not start after 5
pulls, use cold start
procedure. Do not increase
engine speed while chain
brake is locked. Severe brake
damage will result
.
Running
The saw chain should not move at idle, otherwise serious
personal injury may result.
Note: If saw chain moves adjust carburetor according to “Carburetor
Adjustment” instructions in this manual, or see your dealer.
1. After engine starts, allow it to
return to idle and warm up before
using.
2. Move chain brake lever fully
REARWARD to UNLOCK chain
brake.
3. Squeeze throttle trigger gradually
and increase engine speed.
4. The chain starts running when
the engine reaches clutch
engagement speed (see
technical data page).
5. Confirm proper acceleration and
lubrication of chain and bar.
6. Do not run the engine at high
speed unnecessarily.
7. Be sure that saw chain stops moving when throttle trigger is released.
UNLOCK
Shown with optional
Kick Guard
TM
Chain Brake
To Next Page
Loading...
Need help?
General
