Echo CS-500VL User Manual

Table 2
-
l—\
2
&
I
«
i
c
w
Engine
ov^hetted
lairing function
defective i ■■
'Cerburetor
cfefective —
0#wr
troublH'
Chain chmiMI
cut dun
Chdn stops
{Dutch slips
*Chdin pooriv
lubficeted^—
— Improper fuel, uted. fuel with correct mixing ratio. Never
' uiepasottnoof poor quality.
|—Spark plug defective {burntL. Replace.
•At coding fins dogged, air __
does not pus well . Clean tint.
^ Excessive deposits in
combustion chamber. DsassemWe and remove carbon.
f- Point gap Incorrect. Adjust to 0.36 mm (0.014")
Plug damaged or fouled Replace or dean.
^ Combustion poor due to
defective wiring
Cheek muring.
f—High-speed needle
setting incorrect *
.. Readjust
Cerfauntor overflow ... Rafer to Table 1.
^ Air cleaner clogged. Clean as necessary.
^Compression insufficient
{piston ring stuck or worn"
out)
^ Cylinder diromium plating
peeled or worn out
Oisassembfe. check and rapface
if neceoarvr
Replace cylinder.
r^r."^-—.Cl,»,«r,.c«»ry.
Throide is not fully open...... Readjust
lamion incorreci......... Adjust.
Ch«tBwron#v set . Set correetiy.
Depth incorrect. Readjust.
Chain saw {tested against
tru too firmly .
Press lightly.
iutch shoe worn out. Replace.
^No oil in tank. Refill.
Adjust.
HOil contaminated with dust... R insa tank end fill wrth new oil.
delivary
Incorrect
l-Oilvi8COiitv.napproprlan .... Uaeoil with corrsctvhcojctv
' ^ • for summer or Winter.
STORAGE AFTER USE
• Inspeot 9ftd adjust every part of the chair> saw.
- Completely clean every part, and repair, if neceuary.
- A^y thin coating of oil on metal parts to prevent rust.
- Remove chain and guide bar. apply them sufficient oil coabng and wap them up in plastic sheet
• Drain fuel tank, puM starter slowly a few times to drain fud from cvburetor.
o Pour a little amount of dean motor oil in^ spark plug hole, pull starter and tt^an manually cra^k the engine
until die TOP DEAD CENTER,
o Store in a dry araa. free from dust.
15 -

Echo CS-500VL Specifications

General

Brand	Echo
Model	CS-500VL
Category	Chainsaw
Language	English