Echo HC-150 User Manual

24
sharpenIng blades
Level 2.
Parts required: None
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to
severe personal injury. Avoid touching blades whenever possible,
and always wear gloves to protect hands.
1. Clean dirt from the grease tting (A).
2. Carefully pump grease into tting (A). DO NOT force grease. Too
much pressure will force grease past seals and cause damage. Apply
1-2 pumps of grease every 15-25 hours of operation.
3. Wipe excess grease from around grease tting.
1. Move stop switch to stop position.
2. Disconnect spark plug wire.
3. Remove blade guard (see “Blade Guard Remove/Install instruc-
tions”).
4. Slide blades to allow le clearance using slots (A) on bottom of
blade. Do not pry against cutting edges.
5. File each edge carefully. Follow the original shape of the blade.
IMPORTANT
If a power grinder is used DO NOT allow blade to over heat.
6. Install blade guard (see “Blade Guard Remove/Install instruc-
tions”).
7. Lubricate blades (see “Lubrication instructions”).
IMPORTANT
Blades should only be removed and reinstalled by an Authorized
ECHO Servicing Dealer, otherwise premature wear or internal
damage may occur.
A
A
45º
A
6mm (.25 in.) Radius

Echo HC-150 Specifications

General

Brand	Echo
Model	HC-150
Category	Trimmer
Language	English